Mpio DMG Manuel de service télécharger pdf (Page 58)

8. If the original configuration still fails, contact HP and report this as a possible interoperability

issue between the host adapter and the computer.

ASP does not detect any of the Fibre Channel devices

Problem: The ASP recognizes the Celerity FC host adapter but does not detect any of the connected

Fibre Channel devices.

To troubleshoot this problem, perform the following steps:

1. Verify that the Fibre Channel devices are powered on.

2. Verify the cable integrity:

• Check the cable connections.

• Inspect the SFPs for physical damage.

• Replace the SFPs if necessary.

• Inspect the cable ends for dirt or abrasions, which can affect communication.

3. Verify zoning, if any, including the WWPNs of the host adapter port and the EVA ports.

4. For HP Command View EVA:

• Verify that the host entry for the server has been created and the host adapter WWPNs are

correct.

• Verify that the EVA LUNs have been presented to the EVA host entry.

5. Boot Mac OS X and use the ATTO Configuration Tool to set the connection mode to PTP or Loop

(to match your device setting), or set the data rate to the speed of your target devices.

By default, the Celerity FC host adapter autonegotiates these parameters.

6. Save the changes and restart the computer with the Fibre Channel device attached

Fibre Channel device is faulty

Problem: A faulty Fibre Channel device is connected to the Celerity FC host adapter.

To troubleshoot this problem, perform the following steps:

1. Disconnect all Fibre Channel devices from the host adapter and reboot the computer.

2. Attach one Fibre Channel device with a different cable, and then reboot the computer.

3. Repeat 2 until the problem occurs.

4. Watch the LED indicators on the Fibre Channel devices before, during, and after startup.

Drive LEDs should flash at startup when the Fibre Channel port is scanned.

5. If the ATTO Configuration Tool does not launch, verify that the latest Java version is installed.

6. Replace the host adapter.

Computer does not boot with the Celerity FC host adapter installed

Problem: The computer does not boot with the Celerity FC host adapter installed.

To troubleshoot this problem, perform the following steps:

1. Ensure that the host adapter is seated properly by powering down the computer and reseating

the host adapter.

Troubleshooting the Celerity FC host adapter58

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 64

Pas de commentaire

Mpio DMG Manuel de service Page 58