Mpio HD 200 Manuel d'utilisateur télécharger pdf (Page 10)

To switch between MTP and MSC modes

• While MG200 is plugged into your computer, press the Menu ( M ) button to

switch between the MTP and the MSC modes.

Note: If you are using Windows98 SE and need to install the USB driver manually, please

refer to Microsoft Knowledge Base or to MPIO Web Support.

Disconnecting MG200

To disconnect MG200 from a PC

• Place mouse cursor on “Stop a Hardware Device” icon in the system tray, and click

right mouse button.

• Select “Stop USB Mass Storage Device.”.

• Select USB Mass Storage Device from the list of hardware, and click the [Stop]

button.

• When the “Stop a Hardware Device” window appears, select MPIO MG200 USB

Device.

• Finally, click [OK] and disconnect the USB cable.

Windows XP:

Disconnect the USB cable when the “Safe to remove hardware” message appears.

Windows 2000:

Disconnect the USB cable by clicking the [OK] button after the “Safely Remove Hardware”

message appears.

Note: Disconnecting MG200 without going through the above steps may result in loss of

data.

Downloaded from ManualMPlayer.com Manuals

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Pas de commentaire

Mpio HD 200 Manuel d'utilisateur Page 10